Enphase Microinverters

(For all Enphase systems using the Envoy)

1. Check your Wi-Fi signal

Stand near your Envoy and check that your home Wi-Fi network appears on your phone.

If you can’t see your network at this location, the signal is too weak. Install a Wi-Fi extender or move your router closer.

Without a detectable signal, the Envoy cannot connect to the internet.

2. Locate your Envoy communication gateway

The Envoy may be mounted on the wall, inside your switchboard or behind a cover panel.

Press the button below the mobile phone symbol.

A green light beside the icon means the Envoy is ready for Wi-Fi setup.

3. Connect your phone to the Envoy hotspot

Open the Wi-Fi settings on your phone and select the network starting with Envoy_ followed by the serial number.

If asked for a password, enter the last six digits of the serial number shown on the Envoy label.

4. Open the Envoy login page

Open a web browser (Chrome or Safari recommended).

Type 172.30.1.1 into the address bar and press Enter.

5. Log in to network settings

Username: envoy

Password: the last six digits of the serial number.

Tap Sign In.

6. Select your home Wi-Fi network

On the identity verification page, enter the default details:

  • Account: user
  • Password: pw1111

Press Verification to continue.

If these details don’t work, your installer may have changed them. Contact your installer for assistance.

7. Connect the inverter to your home Wi-Fi

Open the Wi-Fi or Network settings.

If your old network is still saved, remove it first.

Select your new home Wi-Fi network name.

Enter your Wi-Fi password carefully. It’s case-sensitive.

Tap Connect.

8. Wait for the connection to complete

Allow up to 3 minutes for the Envoy to connect.

A successful connection will show:

  • “Connected to Wi-Fi” on the settings page.
  • The Envoy showing as online in the Enphase App or Enlighten portal.
  • A solid light on the Envoy.

9. Confirm system monitoring

Open the Enphase Enlighten or Installer App.

Check that solar production and device status are updating.

Troubleshooting tips

  • If the Envoy hotspot doesn’t appear, press the Wi-Fi button again.
  • Make sure your router’s 2.4 GHz band is turned on. The Envoy may not support 5 GHz.
  • If the connection fails, restart your router and try again.
  • Double-check your Wi-Fi password. It’s case-sensitive.
  • If the problem continues, contact your installer or Enphase Support.
Enphase Envoy communication gateway